双激光脉冲打靶形成Gd等离子体的极紫外光谱辐射

高端芯片制造所需要的极紫外光刻技术位于我国当前面临35项"卡脖子"关键核心技术之首.高转换效率的极紫外光源是极紫外光刻系统的重要组成部分.本文通过采用双激光脉冲打靶技术实现较强的6.7 nm极紫外光输出.首先,理论计算Gd¹⁸⁺—Gd²⁷⁺离子最外层4d壳层的4p-4d和4d-4f能级之间跃迁、以及Gd¹⁴⁺—Gd¹⁷⁺离子最外层4f壳层的4d-4f能级之间跃迁对波长为6.7 nm附近极紫外光的贡献.其后开展实验研究,结果表明,随着双脉冲之间延时的逐渐增加,波长为6.7 nm附近的极紫外光辐射强度呈现先减弱、后增加、之后再减弱的变化趋势,在双脉冲延时为100 ns处产生的极紫外光辐射最强.并且,在延时为100 ns处产生的光谱效率最高,相比于单脉冲激光产生的光谱效率提升了33%.此外,发现双激光脉冲打靶技术可以有效地减弱等离子体的自吸收效应,获得的6.7 nm附近极紫外光谱宽度均小于单激光脉冲打靶的情形,且在脉冲延时为30 ns时刻所产生的光谱宽度最窄,约为单独主脉冲产生极紫外光谱宽度的1/3.同时...     

金属衬底在石墨烯化学气相沉积生长中的作用

以过渡金属为催化衬底的化学气相沉积法(Chemical Vapor Deposition，CVD)已经可以制备与机械剥离样品相媲美的石墨烯，是实现石墨烯工业应用的关键技术之一。原子尺度理论研究能够帮助我们深刻理解石墨烯生长机理，为实验现象提供合理的解释，并有可能成为将来实验设计的理论指导。本文从理论计算的角度，总结了各种金属衬底在石墨烯CVD生长过程中的各种作用与相应的机理，包括在催化碳源裂解、降低石墨烯成核密度等，催化加快石墨烯快速生长，修复石墨烯生长过程中产生的缺陷，控制外延生长石墨烯的晶格取向，以及在降温过程中石墨烯褶皱与金属表面台阶束的形成过程等。在本文最后，我们对当前石墨烯生长领域中亟需解决的理论问题进行了深入探讨与展望。     

气相输运沉积制备c轴择优取向的碘化铋薄膜

铋基卤化物材料因其无毒和优良的光电性能而显示出巨大的应用潜力。BiI₃作为一种层状重金属半导体,已被用于X射线检测、γ射线检测和压力传感器等领域,最近其作为一种薄膜太阳能电池吸收材料备受关注。本文采用简单的气相输运沉积(VTD)法,以BiI₃晶体粉末作为蒸发源,在玻璃基底上得到高质量c轴择优取向的BiI₃薄膜。并通过研究蒸发源温度和沉积距离对薄膜物相和形貌的影响,分析了BiI₃薄膜择优生长的机理。结果表明VTD法制备的BiI₃薄膜属于三斜晶系,其光学带隙为~1.8 eV。沉积温度对薄膜的择优取向有较大影响,在沉积温度低于270 ℃时,沉积的薄膜具有沿c轴择优取向生长的特点,超过此温度,c轴择优取向生长消失。在衬底温度为250 ℃、沉积距离为15 cm时制备的薄膜结晶性能最好,晶体形貌为片状八面体。     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

Synthesis of flower-like WS2 by chemical vapor deposition

Flower-like tungsten disulfide (WS₂) with a diameter of 5-10 μm is prepared by chemical vapor deposition (CVD). Scanning electron microscopy (SEM), energy dispersive spectrometer (EDS), Raman spectroscopy, and ultraviolet-visible (UV-vis) spectroscopy are used to characterize its morphological and optical properties, and its growth mechanism is discussed. The key factors for the formation of flower-like WS₂ are determined. Firstly, the cooling process causes the generation of nucleation dislocations, and then the "leaf" growth of flower-like WS₂ is achieved by increasing the temperature.     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

Vacuum-gap-based lumped element Josephson parametric amplifier

We propose a lumped element Josephson parametric amplifier with vacuum-gap-based capacitor.The capacitor is made of quasi-floating aluminum pad and on-chip ground.We take a fabrication process compatible with air-bridge technology,which makes our design adaptable for future on-chip integrated quantum computing system.Further engineering the input impedance,we obtain a gain above 20 dB over 162-MHz bandwidth,along with a quasi quantum-limit noise performance.This work should facilitate the development of quantum information processing and integrated superconducting circuit design.     

Fabrication of an ionic‐liquid‐based polymer monolithic column and its application in the fractionation of proteins from complex biosamples

An ionic‐liquid‐based polymer monolithic column was synthesized by free radical polymerization within the confines of a stainless‐steel column (50 mm × 4.6 mm id). In the processes, ionic liquid and stearyl methacrylate were used as dual monomers, ethylene glycol dimethacrylate as the cross‐linking agent, and polyethylene glycol 200 and isopropanol as co‐porogens. Effects of the prepolymerization solution components on the properties of the resulting monoliths were studied in detail. Scanning electron microscopy, nitrogen adsorption–desorption measurements, and mercury intrusion porosimetry were used to investigate the morphology and pore size distribution of the prepared monoliths, which showed that the homemade ionic‐liquid‐based monolith column possessed a relatively uniform macropore structure with a total macropore specific surface area of 44.72 m²/g. Compared to a non‐ionic‐liquid‐based monolith prepared under the same conditions, the ionic‐liquid‐based monolith exhibited excellent selectivity and high performance for separating proteins from complex biosamples, such as egg white, snailase, bovine serum albumin digest solution, human plasma, etc., indicating promising applications in the fractionation and analysis of proteins from the complex biosamples in proteomics research.     

Coupling nanoliter high‐performance liquid chromatography to inductively coupled plasma mass spectrometry for arsenic speciation

Nanoliter high‐performance liquid chromatography shows low consumption of solvents and samples, offering one of the best choices for arsenic speciation in precious samples in combination with inuctively coupled plasma mass spectrometry. A systematic investigation on coupling nanoliter high‐performance liquid chromatography to inductively coupled plasma mass spectrometry from instrument design to injected sample volume and mobile phase was performed in this study. Nanoflow mobile phase was delivered by flow splitting using a conventional high‐pressure pump with reuse of mobile phase waste. Dead volume was minimized to 60 nL for the sheathless interface based on the previously developed nanonebulizer. Capillary columns for nanoliter high‐performance liquid chromatography were found to be sensitive to sample loading volume. An apparent difference was also found between the mobile phases for nanoliter and conventional high‐performance liquid chromatography. Baseline separation of arsenite, arsenate, monomethylarsenic, and dimethylarsenic was achieved within 11 min on a 15 cm C₁₈ capillary column and within 12 min on a 25 cm strong anion exchange column. Detection limits of 0.9–1.8 μg/L were obtained with precisions variable in the range of 1.6–4.2%. A good agreement between determined and certified values of a certified reference material of human urine (GBW 09115) validated its accuracy along with good recoveries (87–102%).